Nitrile Hose c/w Tails

Part Number: P750XXX / P400XX

KEY FEATURES:

  • Pre-cut lengths with crimped hose tails 
  • Cloth reinforced
  • Hose tails available in 3/4″ or 1″ sizes
  • Suitable for use with diesel and oils

Nitrile hose for diesel dispensing complete with crimped on male threaded BSP hose tails. Optional 3/4″ or 1″ hose tails.

This diesel hose is a specially formulated blend of nitrile compound and PVC. The three layer construction is strengthened by 24 polyester braid reinforcement. It is then heated and chemically bonded to create an extremely strong and reliable hose solution. As it is specifically designed to convey diesel fuel, this hose is resistant to oil and fuel and will withstand prolonged contact. The working pressures quoted within the charts are based on the short term burst pressures calculated at 20°C using a 4-to 1 safety factor. Maximum recommended working temperature is 45°C. At temperatures above 20°C working pressures quoted would be affected. Below -25°C bend radius and flexibility would be affected.

Hose tail variations: There are 3 options for hose tails, 1” BSP Parallel male hose tail, ¾” BSP Parallel male hose tail and 1” BSP taper male hose tail. Use the drop down box to select which is required.

3/4″ Hose Size

  • Internal Diameter – 3/4″ (19.00mm)
  • Outer Diameter – 1 1/4″ (31.75mm)
  • Working Pressure – 75 PSI / 2.4 Bar
  • Burst Pressure – 300 PSI / 20.6 Bar

1″ Hose Size 

  • Internal Diameter – 1″ (25.4mm)
  • Outer Diameter – 1 3/8″ (34.9mm)
  • Working Pressure – 60 PSI / 4.1 Bar
  • Burst Pressure – 240 PSI / 16.5 Bar
Scroll to Top